How to change transmission oil on a Porsche 944

THE WHY?

If your 944 is 25 years old like mine with just over 120,000 miles on the clock then you may have noticed that the gear changes are not as smooth as they once were or maybe your gearbox is whining a bit. Then it's quite possible your gearbox / transmission needs some fresh lubricant.

THE TASK

Quite a simple one really. This is what you'll need.

17mm Hex bit
Torque wrench
Anti-seize thread lubricant
Swepco 201 gear oil (Approx £50) - You get 3.8 Litres in the bottle, the transmission needs 2 Litres
A large syringe
Bowl to catch old lubricant

THE HOW TO

(Amateur mecahnic Job Time approx: 1 hour)

If your transmission is still attached to the car then it's probably best to give it a 10-15 minute drive to warm the old oil up so that it flows out more easily. My transmission was already off the car so I just had to make sure it was on a level surface. The transmission is located under the rear of the car. Take an empty bowl and place it under the left hand-side of the transmission ready to catch the old oil. On the left side of the transmission you will find two identical oil drain plugs situated to the right and below the drive shaft mount.

Start by cleaning off any dirt or rust around the threads on both drain plugs, give them a spray of penetrating oil too. Remove the upper plug first (in case the lower one is seized then you haven't lost all your oil with no way of putting fresh oil back in). Then remove the lower plug using a 17mm hex key, the oil should then start to flow out. Once all the old oil has flowed out stick your finger in the hole and feel around checking for metallic particles left in the bottom of the transmission. If there are then your tranny may need a little more attention than just an oil change. Now is a good time to inspect the condition of the drain plugs. Mine were pretty old and roughed up so I decided to change them for new ones, only a couple of quid each from Porsche. Notice the tapered thread on the drain plugs.

Now apply a little anti-seize thread lubricant to one of the drain plugs and tighten it into the lower hole to a torque of 20Nm. Now fill the syringe with Swepco 201 gear lube which I bought from here and pump it into the upper right hand hole. Repeat until the oil comes level with the bottom of the hole you are putting the oil into. Once you're there apply the same anti-seize thread lubricant to the remaining drain plug and tighten to 20Nm. Job done.